ARO 94412-2 Screw (M12 x 1.75 - 6g x 45 mm) | Replacement Pump Part

ARO 94412-2 Screw (M12 x 1.75 - 6g x 45 mm)

The ARO 94412-2 Screw (M12 x 1.75 - 6g x 45 mm) is a replacement service component intended for Diaphragm Pumps. It is suited to maintenance, repair and overhaul work where the existing component is worn, damaged, missing or being replaced as part of a planned service procedure.

For purchasing and maintenance teams, the manufacturer part number 94412-2 should be the primary identifier. ARO equipment can use visually similar parts across different models, sizes and generations, so the complete pump or equipment model should be checked against the applicable parts list before installation.

Product Identification and Application

This listing identifies the component as Screw (M12 x 1.75 - 6g x 45 mm). The available application information associates it with Diaphragm Pumps. Use that application as a selection guide, but verify the exact model and parts-list position whenever the repair involves a model-specific assembly.

The available product data identifies the component material as Stainless Steel. Use this material designation when comparing the replacement with the existing assembly and any chemical, temperature or corrosion requirements.

• Part number: 94412-2
• Component: Screw (M12 x 1.75 - 6g x 45 mm)
• Material: Stainless Steel
• Application: Diaphragm Pumps
• Part number: 94412-2
• Brand: ARO

Maintenance and Replacement Guidance

Before removing the original part, isolate the equipment and follow the shutdown, depressurization, lockout and service instructions for the specific ARO model. During disassembly, note the orientation of the existing component and inspect the mating surfaces, fasteners, seals and nearby parts that may affect the repair.

Check the removed screw (m12 x 1.75 - 6g x 45 mm) for wear, cracking, distortion, corrosion, thread damage, surface scoring, leakage marks or other signs of deterioration that are relevant to its function. If neighboring parts show similar wear, replacing a single component may not fully correct the underlying service condition.

The available service information indicates a typical assembly quantity of 12. This describes the documented assembly requirement, not necessarily the supplier package quantity, so confirm the quantity being purchased.

Why Model Verification Matters

ARO product families can share similar component names while using different materials, dimensions, threads, hardware sizes or assembly configurations. Selecting by appearance alone can lead to an incorrect order. Match 94412-2 to the complete equipment model, current parts diagram and service section whenever possible.

For an accurate maintenance order, confirm the part number, full model, material when specified, required quantity, service location and whether the repair is being completed with an individual part or a larger service kit. This helps reduce duplicate purchases, installation delays and avoidable downtime.

Ordering ARO 94412-2

When requesting a quote or placing an order, provide ARO 94412-2 together with the complete pump or equipment model. If the machine has been rebuilt or modified, compare the existing assembly with the current parts documentation before purchase.

The goal is to match the documented replacement component to the actual service configuration. Using the exact part number and verified equipment information gives technicians and buyers a clearer, more reliable path to selecting the correct screw (m12 x 1.75 - 6g x 45 mm) for the repair.